Dog Training Collar with Wireless Remote USB Rechargeable Collar Waterproof Home Dog Training Device Vibrating Dog Collar with Remote Control Vibration/Beep Mode Dog Barking Collar 500 Yards Range

How to turn on the collar and remote controller?and pairing to collar ?

1.Turn on the remote controller by pressing any button on the remote.

2.Press power button once to turn on the receiver,will hear one beep sound, Press again to turn off,will hear two beep sound.

3.Press power button 5 seconds on the receiver to enter pairing mode.will hear a beep and LED indicator will become solid. Keep 10 seconds to finish the pairing.

4. One remote controller can control three collars, if you need extra collar, you can order it from our store.

To find your dog's recognition level:

This professional good training aid for dogs of any age. They can hear you from a long distance!Let your dog stop barking according to your instructions, sit down, lie down, recall, go to toilet training...Dogs will not respond to all frequencies, but you can adjust the pitch of the corresponding frequency to make it best for your dog.Rotate the screw in or out until your dog responds to the strongest response to adjust the frequency!

Very Important Tips：

Do not put the collar on dog for few days continuously, otherwise it will caused hotspots on the neck.

Q: The length of the PU belt collar ?

A: 27.5 IN (70 CM)

Q:What should i do if the training collar set don' t work?

A: 1. Check the battery power of the Remote and Receiver ,if low power, charge them.2. Check the level, if you choose vibration mode or Strong Vibration mode，adjust to above 001.

3. Check the Receiver , if you don't turn it on, press the Power button of the Receiver.

4. Check the channel, if you choose the different channel, press up/down button to adjust.

5.Repair the Remote with the Receiver.