Openport Vci J2534 Passthru Obd2 Programmer For Consult 3 Plus Diagnostic Scan Tool Software Version 75.15 Install Support

OverviewSummary: You modify the registry and diagnostic tool file to add your interface name exactly as it is in the registry. When your interface is connected to the car, then the laptop, then open c3+, and most likely your interface will not show as being connected. So you go into the program and select vi/mi. Do Not Select Connect. The program will freeze up. Just click on the interface that shows serial number 1234567 and then select cancel and you should now see your interface showing as connected in the home screen of c3+. You should then be able to use the program but if you back out to the home screen you will see that your interface does not show up as connected. Seems like it disconnects itself but as long as you follow the same steps and Never select connect when you are in the select vi/mi menu you do not want the program to freeze. for-Nissan Consult+ works with many j2534 devices but does not fully function. A few other j2534 devices with no problems other than the live data issue and sometimes will not read vin number or it will read vin number but it will not decode it correctly. The bottom line is that any j2534 does not work properly for C3P. You can not do programming. If you just trying to do scanning, j2534 works for C3P. If you are looking for another function such as programming and bi-directional test etc, forget about it. There is no way other than genuine C3P VI2. If you are dealing with a 2018 up car, R2R software from for-Nissan will work for both programming and scanning. R2R software works with J2534.