s2 foamy by innovacar snow foam car shampoo with active foam 1000Ml

OverviewTo wash a car that has already gone through a pre-wash, we recommend using the two-bucket method. The main steps are: Checking that you have removed bracelets and wristwatches during washing to avoid inadvertently scratching the bodywork. Prepare two buckets with their grids on the bottom: these grids are set up to let debris and residues settle, keeping the water clear of any contaminations. Prepare two high quality mitts. Use the first bucket with the diluted product. We recommend first adding the product and then the water to mix the product better and already create a foam. For the maximum cleaning capacity, it is possible to use hot water between 35 and 40 degrees. Mix to make the solution homogenous before use. Fill the second bucket with water. This one will be for rinsing. Use a clean mitt. Dip the mitt in the bucket with the product and wipe the top of the car. Dip the mitt in the rinse bucket and clean it to remove debris and impurities. Take the second clean mitt and use it for on the lower part of the car. It is recommended to use two separate mitts for the upper and lower parts to prevent the lower part, which is usually more covered with debris, from contaminating the upper part. Proceed with rinsing with plenty of water, from the top down. It is important to rinse the mitts frequently to prevent the dirt or debris from depositing and becoming sources of marks on the bodywork. Do not wash in a circular manner, this could create streaks. If used with precompression pump or with the two-bucket method: the recommended dilution ranges from 1:25 to 1:50, i.e. use 40 ml to 20 ml of product and fill the remaining part with water (from 960 ml to 980 ml) to obtain 1 L of ready-for-use solution. For frequent cleaning, the dilution can reach 1:500: therefore use 2 ml of product and add the remaining part of water (998 ml) to obtain 1 L of ready-for-use solution. For cleaning with foam gun: the recommended dilution is 1:12; use 80 ml of product and add the remaining part of water (920 ml) to obtain 1 L of ready-for-use solution. While dispensing, the actual final dilution can reach approximately 1:195. For frequent cleaning, the dilution can reach between 1:25 and 1:50: therefore use between 40 ml and 20 ml of product and add the remaining part of water (from 960 ml to 980 ml) to obtain 1 L of ready-for-use solution. While dispensing, the actual final dilution can reach approximately 1:390 to 1:765. If used for pre-washing for weekly dirt: the recommended dilution ranges from pure to 1:20; use up to 50 ml of product and fill the remaining part with water (950 ml) to obtain 1 L of ready-for-use solution. While dispensing, the actual final dilution can reach approximately 1:315