Dolphin Polyurethane PU Insulating Foam Sealant for Door Furniture Ceiling Gypsum Spaces Crevices, 750 ML

Application Instructions: Shake the aerosol can for at least 20 seconds. Fit the gun on the adapter Surface should be free from grease and dust Moisten surfaces with a water sprayer prior to application For non-conventional substrates a preliminary adhesion test is recommended Fill holes and cavities for 65 %, as the foam will expand Repeat shaking regularly during application. If you must work in layers repeat moistening after each layer Health & Safety Recommendations : Take the usual labor hygiene into account. Always wear gloves and goggles. Remove cured foam mechanically. Never burn away. Consult label and material safety data sheet for more information. When vaporizing (for example with a compressor), additional security measures will be required. Use only in well ventilated areas. Note: Physical properties shown are typical and are to serve only as guide for engineering design. Results are obtained from specimens under ideal laboratory conditions and may vary upon use, temperature, and ambient conditions. Right to change physical properties because of technical progress is reserved. This information supersedes all previously published data. Yields shown are based on theoretical calculations and will vary depending on ambient conditions and particular application. Read all product direction and safety information before use. Consult local building codes for specific requirements regarding the use of cellular plastics or urethane products in construction.