RACO Ready Mix Plaster | Instant Mix for Wall, Floor & Ceiling | Crack Filler | Ready-to-Use Cement with Fine Sand & Special Additives

RACO Ready Mix is a cementitious fibre reinforced ready mix plaster used for traditional plastering works in a clean and speedy manner, while keeping a homogeneous mix. Due to its high content in additives, it allows better shrinkage control as well as improved workability, bonding and curing.

RACO Ready Mix is recommended for external and internal plastering on block walls, ceilings, concrete surfaces, bricks and for general filling up.

RACO Ready Mix can be applied traditionally by hand or by using modern plaster-spraying machines. It should not be used on painted surfaces or floors. For the application on Light Weight concrete blocks.

★ Instructions for Us,

✧ Substrate Preparation
1. Ensure the surface is rigid, clean, and free from contaminants.
2. For masonry blocks, RACO Ready Mix can be applied directly.
3. Dampen the substrate with clean water a few hours before applying RACO Ready Mix


✧ Product Preparation
1. Mix 1 kg of RACO Ready Mix with 140–180 millilitres of clean water using a hand mixer or mechanical mixer until smooth.
2. Let the mixture rest for a few minutes.
3. For spraying machines, mixing is automatic.


✧ Product Application
1. Apply plaster to the prepared surface by spraying or using a trowel at a thickness of 10–20 mm in one layer.
2. Finish the surface with a wooden or steel float.
3. Ideal application temperature: +5°C to +35°C. If above 35°C, use cool water to mix and keep the material below 30°C.
4. Allow the plaster to set before curing.
5. For additional thickness, apply in two layers: roughen and cure the first layer, then apply the second layer at least 48 hours later.

✧ Curing
Protect the freshly applied plaster from direct sunlight and wind. Cure the plaster by spraying it with water 3 to 4 times daily for at least three days.