LR-NG300 Remote Control Alarm Set with Motion Sensor

نظرة عامةLorex LR-NG300 Remote Control Alarm Set with Motion Sensor
Wireless burglar alarm system is used as a precaution against theft in homes, workplaces, warehouses, etc.
Ideal for use in places.
When the system is installed, if there is an unauthorized entry, the system emits a loud alarm sound.
It has a wide detection area with a wide viewing angle.

This practical product, which you can use as a door, room or car park alarm, comes with 2 remote controls, mounting bracket and alarm with signal motion sensor.

The most important advantage of the product is that it has practical wireless installation.
Alarm system contents

1.Main unit with motion detector
2.Remote control
3.Mounting bracket

Commissioning:

Set up your alarm system with the remote control.
Direct the remote control to the device and press the button on it once.
There will be a beep from the device and the LED will give green light for around 18 seconds.
You must leave the place within this time to prevent the alarm from going off.
After you leave the place, when someone comes within 5 meters of the device, the LED will flash with red light and the remote control will be activated.
It will wait for it to be printed.
If the remote control is not pressed within 5 seconds, the alarm will sound for approximately 30 seconds and the alarm will sound again when moving.
You do not need to run any cables to your system.
It has a 90° viewing angle.


Deactivation:
Direct the remote control to the device and press the button on it.
Detection distance 5m
Siren sound power 105 db
The panel works with 4 1.5v batteries.
Battery not included.